okay guys i found a few min so i drew up a wiring diagram and took some pics. i have a pic where i routed the wire up the frame and through the clutch cable loop w/ the cable. then just pics of the wiring if u can read the diagram its easy. basicaly connect the wires from the magneto directly to the cdi this is the black/red and white/red wires. then create a ground for the black coming out of the magneto and the cdi. i have them all conected to a common ground wire. then connect the black/white wire to whatever switch you use and ground the other side(again i use common ground). then make a wire to run from the cdi box to the coil. the orginal wire is orange. just connect it to the orange wire coming out of the cdi. the yellow/red wire is not used. you can now remove the tors switch from the throttle, remove the voltage regulator, the run/light switch, and tors box. hopefully that is enough info if not ask me ill try to help as much as i can. i'm not sure if this will interfear with newer stuff but it shouldn't b/c this is the least amount of electronics needed to create spark and have the quad fire.