Need help with clutch

[blasterproject]

I bought a 2000 blaster for cheap because it needed some new clutch rods because one was possibly broken but when i took it apart and tried to get the clutch rods out the one that is on the shifter side of the engine is stuck and i cant get it out. any suggestions or anyone had same problem?

 

[03blasteryfs03]

put some greese on the end of a rod then go in the hole and presss lightly then pull out

 

[03blasteryfs03]

or pull the clucht cable

 

[gonzo]

try a magnet down the hole, if that doesn't work pull the actuator arm out and with compressed air blow it out, important! keep a rag over the end of the shaft so you don't impale somebody! I like to use a box to help contain it.

 

[Kennedy_Power]

try a magnet down the hole, if that doesn't work pull the actuator arm out and with compressed air blow it out, important! keep a rag over the end of the shaft so you don't impale somebody! I like to use a box to help contain it.

That works most of the time
The blaster clutch and the banshee clutch set up really sucks
Good luck

 

[blasterproject]

no its not just sitting in there like it should be it is stuck in there to the point that i cant even get it to move at all. almost like it got bent inside there and is wedged or something

 

[fioz600r]

Do you have the motor in or out of the Blaster? Also did you get the little ball out?

 

[blasterproject]

it is out and yes i have the ball out because there was never one in it