Need Help!! Blater idles But when i push the throttle it dies!!

[mxXxrider88]

I put a 2003 motor in my 1998 blaster. I grounded the extra green wire from the new motor and the quad starts right up but only idles. And when i disconnect the TOR box it shuts off too. I cleaned the carb, put in a new plug, and still nothing. Any kind of help would be greatly appreciated!!

 

[super noober]

I put a 2003 motor in my 1998 blaster. I grounded the extra green wire from the new motor and the quad starts right up but only idles. And when i disconnect the TOR box it shuts off too. I cleaned the carb, put in a new plug, and still nothing. Any kind of help would be greatly appreciated!!

u need to cut the tors wires and splice them together to complete the circuit

 

[Blaner]

u need to cut the tors wires and splice them together to complete the circuit

ditto, do that then try it out

 

[mxXxrider88]

The wires coming out of the TORS box or the wires coming from the harness?
Thanks for throwin out ideas

 

[Blaner]

there are two wires coming from a microswitch on the throttle housing on your handle bars, they need to be spliced together. and then the two wires coming from the grey plug on the carb i think they are solid black and the other black with a yellow stripe.

REMEMBER: you must splice the end going to the brain box and not the ones going to the carb or throttle.

ie: if i cut off your arm, you bandage your stump, not the dead arm i just cut off

 

[mxXxrider88]

That worked!! Thanks for all the help!! Spliced those together and it fired right up!! Thanks again

 

[super noober]

That worked!! Thanks for all the help!! Spliced those together and it fired right up!! Thanks again

no problem man B)

 

[Blaner]

good work man, glad to help!