need a favor...

[89blaster89]

I just bought a 400 rear shock and kor bushings but didn't buy the bolt for the top with the bushings, thought I could use my old one but I guess its to fat so im just going to buy one from home depot that fits and uses a locknut,

what im asking is can someone tell me the length of the upper bolt that goes through the top shock mount please and thanks in adavance

 

[Awk08]

shoulda let ken supply it !

1/2" longer than your stock one should work to allow 1/4" extra each side for the bushings.
you'll need one with a smooth shank long enuf and prolly have to cut the threaded section down to length,
do not run one with threads in between the bushings/shock mounts

 

[89blaster89]

shoulda let ken supply it !

1/2" longer than your stock one should work to allow 1/4" extra each side for the bushings.
you'll need one with a smooth shank long enuf and prolly have to cut the threaded section down to length,
do not run one with threads in between the bushings/shock mounts

yeah I would if I cud! but I didn't know I would have to lath the stock one down,

what was the total length of bolt I will need? sorry blaster is at gramps house other wise I would look myself

 

[Awk08]

no lathe needed, put nut on, cut off with sawzall, hacksaw or wafer wheel on grinder.
remove nut to clean threads.

i can get you a length tomorrow if nobody else does

 

[89blaster89]

alrighty thanks, or maybe ill just order the bolt from ken