More help....

[XXXAngel1978]

I have been trying to figure out why my wheeler was not idling I had to constantly keep on the throttle. Well I replaced my throttle cable today. I started it and it was finally idling, but when I pushed on the throttle it bogged down. I let it sit for a couple hours and now I can't get it to kick over. Anyone have any ideas? Also is there any websites I can go to that have free downloads of wiring schematics for a 2001 Blaster? or a service manual? Please?

 

[liljatownboy]

is the engine locked up (by you saying it wont turn over)? change your plug!!!

 

[Unstock240]

Is the tors removed? Mine had a similar problem the idle screws did nothing until i removed tors?



http://www.rydindirty.com/blastermanual.pdf

This thing is a life saver. I suggest you wait for it to load and then save to your pc for quicker access.

 

[XXXAngel1978]

No the tors is still there....going to remove it asap!! No the motor is not locked up. I can't get it to start.

 

[liljatownboy]

check your reeds and change the plug first!!