Mix Oil Help ?

[ToHeavyFoCmt]

Hi I was wondering what kind of mix oil and motor oil I should run. This is my first blaster and I'm building the motor to the sky haha. Vito's 240 kit, 4mm hot rod crank, full dmc alien exhaust, vforce4 reeds, 34mm pj carb, K&N filter. I don't want to put the money into this and mess it up because of junk oil haha thanks for your help !!

 

[gsustaitav19822]

most of us use 32-1 ratio with good quality oil yamalube, maxima super m etc

 

[ToHeavyFoCmt]

I don't wanna sound stupid haha but what about for the crank cases just a normal 10w30 ?

 

[gsustaitav19822]

no oil on the crank thats why you pre mix, now if you are talking in the clutch side i use gear saver 80, i have also used valvoline 10 40 for motocycle just make sure is safe for wet clutch

 

[ToHeavyFoCmt]

Awesome thanks a lot for your help. Can't wait to get this beast running !

 

[tbrooks]

Yep, 32:1 of good 2 stroke motorcycle/atv oil and oil approved for wet clutches, some people even use atf. I don't know from experience, but that larger carb may not work as well as you think with the DMC. Large carbs are usually reserved for right bend pipes, with more top end. Others should chime in and give some more experienced opinions

 

[ToHeavyFoCmt]

I had the carb given to me buddy of mine sheared his fly wheel key but thought the carb was the problem and it wasn't ! So I was told to run a 160 or 170 main jet and it would run fine. Rich rather than lean. I was just worried about not getting enough fuel with such a big bore