Kick Starter Probs

[FordMan7072]

I was working on repairing the bottom end for my blaster and I'm having problems with the kick starter I had to pull the clutch all apart and pull out the shifter and spin it around. I have the book on rebuilding the blaster and it didn't make a lick of sense but I tryed my best to follow it and now when I try to kick over the motor the kick start dosen't spring back up you have to spin the motor over by hand to get it back. Any ideas on what I might have screwed up?

 

[royalt67]

There is a hole in the case, near the top, by a screw hole, that the end of the spring goes in. Wind the spring about 1/2 turn clockwise until you can put it in the hole.

 

[FordMan7072]

There is a hole in the case, near the top, by a screw hole, that the end of the spring goes in. Wind the spring about 1/2 turn clockwise until you can put it in the hole.

I did that but maby I didn't wind it tight enough? The motor dosen't have a top end on it right now so i can spin the crank by hand and the kick stater moves as I crank spin it but it will olny go so far each way til it stops.