Jetting help

[89custom]

Honestly, im totaly screwed when it comes to jetting. i need to get this new carb right, and i need something to start at. ita a Mikuni TM series flate slide 36mm.

Mods:
Dyno Port exhaust
Vforce3's
uni foam filter/F7 airbox with outerwears lid
vitos 240 kit .020 bore

havent cracked it open yet, but the guy said he never tuned it and wasnt sure if it was ran with a blaster or not.

thanks.

 

[89custom]

i think this is the only post someone has not responded in a long time.

cmon i need some help. the shop im at has a couple riders on blasters so they have some jetting specs, but non are done up like mine.

 

[djack12]

you should ask pitboss45. maybe PM him. im sure he will be able to help you out. you did buy stuff from him.

 

[89custom]

i did?

 

[89custom]

oh sh*t, he runs projectblaster? i just looked up the valley cycle thing and its part of projectblaster and f7.

if he reads this, or anyone that has it, i need the instructions on were to chop my airbox out to fit the new one. says it was supposed to come with it, but didnt. i could do it myself but i really dont feel like messing anything up.

 

[djack12]

i think his is valley cycle and his son runs project blaster. dont quote me on that.

 

[89custom]

iight either way i need to somehow get a cutting layout for that airbox and maybe some help.

my quad can run right now, its just i dont have the carb tuned. not like i could drive it, have no suspension lol.

 

[djack12]

well contact them in the moring, or PM pitboss45 and ask him.

 

[blaster77]

hi im new to this blaster forum i need some help i rebuilt my stock carb and now my bike wont stay running i have to spray carb cleaner in it to get it to start and once started i have to hold down the throttle a little to keep it idle and when i rev it up it bogs out any advice