i have a yamaha blaster with a 80 over cylinder 68 mm piston and it is ported and polished should i gett it jetted if so what jettss should i get i have stock carb
jetted??
- Thread starter blasterbooy23
- Start date
if thats all thats done to it then your jetting should be stock with no changes needed, unless you have a pipe or aftermarket airfilter or no lid on the airbox then your stock jet it fine
thats usually the case, but it wouldn't hurt to do a plug chop to be absolutely positive...........
http://www.blasterforum.com/do-yourself-20/how-plug-chop-38674/
I dnt have a aftermarket exaust butt i was lookin in to the air box to take the lid off wat would yu do
if you ride in heavy water or very dirty conditions ?
leave the lid on
if not, remove the lid, adjust airscrew, bump main jet 1-2 sizes, then plug chop, drop 1 size if needed according to the plug chop
airscrew.....
http://www.blasterforum.com/carburetor-138/adjusting-your-airscrew-pilot-jet-51060/
plug chop.....
http://www.blasterforum.com/carburetor-138/how-plug-chop-53237/
Yeaa i ride in alot of mud and dirt and thanks for the help and is there any mods or any thing that yu would suggest to do ro the bike
