i was riding yesterday and my quad wont idel. I messed with the idel screw and nothing worked. it would rev up and stay there and not come down. also it backfires a lot when i get off the throttle when i let off the gas. i am not sure what that is either. any help would be great.
idel problems
- Thread starter H0LESH0T
- Start date
my blaster has had the idle screw removed but my lt160 used to backfire if it was reving to high i sugest u take the idle crew completly out and then put it in the least u can increasing very little untill you get it at a good level
hope this helped
hope this helped
u need to adjust the air screw...and then adjust idle.turn air screw on left side of carb all the way in.back out 1-1 1/2 turns untill best throttle response. then adjust idle on top of carb
just an idea but i mixed the oil and petrol wrong (not enough oil) and my blaster kept over reving and back firing
Taking it apart and cleaning it wouldn't hurt at all.Blow it out good with an air compressor,throw it back together and see what happens.That would also be a good time to inspect your reeds and cage.
well since you dont have any mods listed.. to help us better what is done to your blaster? or is it stock?? improper jetting can make it idle high also.... lean will have ahigher idle, same with timing advance will idle up more...
i would def. do what blaster 326 says. cleaning the carb out thoroughly will fix running issues that occur all of the sudden one little piece of dirt can create alot of running problems. so i would deff. take the carb apart and clean it.
cleaned carb and put it back on then i turn the idel screw and the idle will go way up. not sure what that is all about. also the throttle sticks and it will run wide open at times. i turn the idel all the way down and give it some gas and it will run its balls off. i turn the key off and the kill switch and it still wont shut off. the only way to get it to turn off is by putting it in gear and holding the front brake. any ideas?
does the throttle cable itself feel like it is sticking? it may be misaligned or something at the carb. or your throttle cable could be sticking inside that outer coating of the cable. check those things out
did you check the slide on the carb? is it goin up and down like it should? did you, did you check your jetting? what are you jetted at?
hi i think i have the same problem i blasteer wionrt start if i jus kick it i hav to giv it gas and kick at the same time and do u thhnk its my jets and also how to u adjust ur idle srcew like were is it i think thats my probm also how do u fix ur throttle cable becuase wen i get y quad started i turn my handke bars to the left it turns offf my wen i keep my handle bars pointed to the right it stays on ??
pllzzz helpif u hav any ideas this is my first blaster
pllzzz helpif u hav any ideas this is my first blaster
Similar threads
