I stripped my blaster and I took my head off today

[TheWalkingPlague]

When i took the head off it looked very clean and the rinds and piston were fine could i still need a rebuild my dad says i dont but want to see what you guys have to say

Thanks for the help guys

 

[TheWalkingPlague]

my blaster also has the stock jet and it always runs rich i run 40/1 so i don't know why and could the problem be in the carb. forgot to mention
thanks again

 

[TheWalkingPlague]

if i get a carb. what size should i get i can get two keihin pj 34mm for $175 so let me know if that would be ok if i have a fmf pipe and a aftermarket air filter

 

[specialized7]

i have a 30mm keihin from cpw forsale

 

[TheWalkingPlague]

pmed you
your blaster is badass i wish mine was 3/4 that nice man

 

[super noober]

my blaster also has the stock jet and it always runs rich i run 40/1 so i don't know why and could the problem be in the carb. forgot to mention
thanks again

isnt that leaner than 32-1? the cylinder walls looked good?

 

[03blasteryfs03]

i run mine 100;1 all day never fryied on me and my dad used to run 150:1 in his race sled

 

[super noober]

i run mine 100;1 all day never fryied on me and my dad used to run 150:1 in his race sled

ummm ok, but what does that have to do with his problem?

 

[Blasterdude27]

i run mine 100;1 all day never fryied on me and my dad used to run 150:1 in his race sled

But I thought you had no powerband?:-/

 

[mystahagy]

When i took the head off it looked very clean and the rinds and piston were fine could i still need a rebuild my dad says i dont but want to see what you guys have to say

Thanks for the help guys

compression?

The message you have entered is too short. Please lengthen your message to at least 15 characters.

 

[TheWalkingPlague]

everything looked clean and i dont have anything to check the compression and dont know where to get one for a good deal

 

[TheWalkingPlague]

i am probally getting ported by flotek and sending him it to see if it needs bored i guess

 

[super noober]

i am probally getting ported by flotek and sending him it to see if it needs bored i guess

i have a feeling that will solve all your problems. I:I

 

[hickskateboarder]

make sure you send him the piston too so he can check clearances. my suggestion is even if it doesn't need bored, i'd have him hone it and throw a new set of rings in so u know it's fresh on that new porting.