How to clean airfilter????

This is off of my web site.

Without a doubt, the number one cause of engine failure is DIRT. When dirt enters your cylinder, it's mixed with two stroke oil and becomes a very destructive kind of lapping compound. Kind of like liquid sand paper. Dirt can take its toll on an engine quick. Dirt can find its way into your engine many ways. Some of the most common ones are :

1. Torn or disconnected air intake boot
2. Spark plug hole

3. Power valve covers

4. Crankshaft seal

5. Faulty air box

6. Dirty air filter

7. Blown exhaust pipe O rings


Of all these sources, the dirty air cleaner is the most common. Lets face it , we all hate to clean our air filters. Cleaning your filter after every ride is a must in a good maintenance program. Here are a few tips that may help.

Get a clean five gallon bucket and fill it with kerosene. Dunk your filter in and squeeze out the mung. Do this several times. Next ,rinse the filter out in hot soapy water. Your kitchen sink works best for this as long as your mom or wife isn't looking. Also get her blow dryer and run out to the garage before she gets wise to you. Use the dryer to evaporate the water in the filter. When the water is out, re-oil the filter and squeeze out the excess oil. Grease the sealing lip of the filter with a thin coat of waterproof grease. Bel-Ray works great. Clean the air box and re-install. I like to have three or four filters ready to go all the time. I store them in Zip-lock bags and keep them with my spare parts. As far as oil goes, DON'T ever use anything other than filter oil. I use Bel-Ray foam filter oil. I also like the Twin-Air brand filters. They are smaller than stock and allow more air to flow in the box. Filter oil is messy . Try some rubber gloves. It makes the job a little neater.

never saw this post being on here since i joined but just did today and
i agree with STEALING the wifes HAIRDYER to dry your filter
i have been doing it for years since i was 17yrs old before a wife..Which was 19yrs ago
especially on a 4stroke,put a wet filter on a 4 stroke start it and watch the water get blown out of exhaust bad idea by the way:D
 
Last edited:
  • Like
Reactions: Markblaster
I have used the K&N filter recharge Kit on my Pod style filter I had in my BMW. Still have the cleaner and oil as I have a K&N for the Blaster and pre-filter.
 
the one time i did wash my uni filter was with gas.
a little bit of gas in a whipped cream container and soaked it.
Out came all of the dirt and nasty and outcome a clean uni.
Probably not the best way to clean it but it worked and i dont have air filter cleaner at all.