how do you know if your piston rings are in the right spot please reply quick

[daulton_w]

i have my new piston om the crank and i need to know how and where to put my piston rings i have a 2004 blaster

 

[88' blaster]

there are pins in the side of the piston.

 

[yzrider]

at a point he shows where the rings should sit, hope it helps

 

[Larry's Shee]

Markings on rings go up. Pins are to each side of rear port.

 

[daulton_w]

thanks so much guys i got the rings right but when i sit the top end down i kjicked it and the piston went up and i went to kick it again and it wouldnt movove so i picked the jug up and put the piston in it again sat it down and it did the same thing

 

[Larry's Shee]

Is this a new fresh bore? If so are the ports champhered? Are the intake windows (holes) facing the carb? Have you watched the vid linked above? Do you have head on when you try rotating it?

 

[daulton_w]

No I dont have the head of my jug on.

 

[hudack]

here.....
http://www.blasterforum.com/engine-13/how-install-cylinder-31635/