Do you just put on a reed spacer, or is there another way? I need to figure out before Sunday.
thanks
thanks
Last edited:
how do you guys deal with clutch clearance with bigger carbs
- Thread starter motor mouth
- Start date
A reed spacer works well,thats what I used.I have seeen 34mm keihins bolt straight up without a reed spacer and clear the clutch arm with no problems.
you can always bend the arm down a little, as long as you pay attention when your doing it so you can adjust your clutch in the future....
I think I am having a problem with this also, seems like its hitting the bowl of the carb, I'll find out for sure when I put my carb back on.
xxxxx2, no problem at all
but if you already know that it hits then your gonna need a reed spacer
also make sure that ur clutch arm is lined up with the flat mark on the case....if the arm is behind that mark your clutch is out of adjusment
good tip bro, i was having this problem too. i just tilted the carb a little like yb suggested and it worked fine. but after replacing my crank seals and having to re adjust that arm to line up with that mark on the case, i dont have to tilt it anymore. i can run it straight up and down and it doesnt hit. its close but it clears..
I looked and its out of adjustment. Now I'm going to have to take off the clutch cove I just put on 2 days ago, and try to find a place with a gasket in stock.
Thanks everyone.
Thanks everyone.
