engine together was doing my warm ups and cool downs and it popped into gear by itself started draining crankcase and a small half inch cylinder fell out what is it from??
Last edited:
hey really use some HELP still under rebuild
- Thread starter BillsBlast
- Start date
awww come on... it's not that bad!
At the very most I could see buying a motor over this certianly not selling the blaster.
At the very most I could see buying a motor over this certianly not selling the blaster.
you would regret selling it!!!
take a pic of the part that fell out
what sealer did you use on the case halves? sounds like a leak there
I only use yamabond
ask for help if you need it, lots of good people on here willing to help
its pin in shifter fork the motor is already torn down AGAIN and splitting cases tomarrow thanks everyone for helping to figure it out
Take it back down and pay extra close attention to the three shift forks. It certainly sounds like the pin in the back of one of the shift forks slipped out while you weren't looking. They're sneaky little devils that can sneak out in an instant.
need some help with my engine just finished rebuilding it and i started up, it ran for a min or so and then it shifted into gear on its own and then stalled out cause i wasn't hanging on it, any advice or help thanks,
