Help

[Jeffro]

Got a issue with my blaster 200 throttle is not sticking but seems like it when putting around it's OK but hit power Band and it's wide open and and it's to the point of almost blowing up scary ride but can't figure out what is the problem

 

[bummer981]

You might have an air leak, have you leak tested it?

 

[Jeffro]

How do you test it for leaks I'm new to the blaster

 

[Awk08]

How do you test it for leaks I'm new to the blaster

how to: http://www.blasterforum.com/threads/how-to-perform-a-leak-down-test.44653/

build or buy one: http://www.blasterforum.com/threads/leakdown-testers.55015/page-5#post-791943

 

[Larry's Shee]

FYI, multiple threads help no one
What does the plug look like ?

 

[Jeffro]

FYI, multiple threads help no one
What does the plug look like ?

Just changed it yesterday and didn't help much

 

[Larry's Shee]

Just changed it yesterday and didn't help much

That's nice, but what did it look like ??
Description of the plug may be a clue to what is going on.

By off chance is it blowing a lot of stinky smoke ??

 

[Jeffro]

That's nice, but what did it look like ??
Description of the plug may be a clue to what is going on.

By off chance is it blowing a lot of stinky smoke ??

The plug was caked with black gunk

 

[jbuckster07]

I would also suspect maybe a bad clutch if once you get into higher rpms it goes to WOT fast!

 

[Jeffro]

I would also suspect maybe a bad clutch if once you get into higher rpms it goes to WOT fast!

Just got a tusk clutch kit and planning on changing it what's the best oil for a wet clutch in the blaster thanks

 

[Blaaster]

The plug was caked with black gunk

It would pay to leak test it before you start it again, you may have a leaky oil seal on the gearbox side.

 

[Jeffro]

It would pay to leak test it before you start it again, you may have a leaky oil seal on the gearbox side.

What does that usually cost to have it tested

 

[Jeffro]

What does that usually cost to have it tested

And if it's leaking a little air is that why it is run's full rpm after half throttle and slowly clams down (not sure how to explain it)

 

[Markblaster]

buy a leak tester or make one.
http://www.blasterforum.com/threads/leakdown-testers.55015/