Help idenifying flat slide carb

[jjj_85]

One of my co-workers has a carb and we cant figure out what exactly it is. It is a Sudco Mikuni Flat slide carb. Here are the numbers on it T35 1, p312, and there is a TM on it. I have been to Sudco's website and cant find anything involving a 35. Unless we miss read the number, I cant find anything for this carb. Any ideas? Would this carb be usable on a blaster?

 

[L.T.]

get a pic up if you can

 

[jjj_85]

I was plannin on it, im gonna bring my camera to work tomorrow and snap a few.

 

[jjj_85]

I forgot to bring my camera to work with me...go figure. I have been looking over the internet now for a bit with the carb infront of me and believe it is a Sudco TMX 35 mikuni flat slide. Will this work on a blaster and what would I need?

Heres the site
http://www.sudco.com/Carburetor01.html

 

[03blasteryfs03]

ya get a pro designs intake to go up to a 35 mil

 

[ROCKSTAR]

it will work on a blaster all you need is an intake for it to fit in. suzukis had flat slide mikunis from the factory. i have 2 34mm flat slides for sale. heres pics.....look like yours?

 

[jjj_85]

That looks alot like mine, your typical flat slide. What would I use for a throttle cable with this thing and will it be to big for a +3 crank, p&p, piped, VF3 motor? I think I am going to have Flotek do the top end. This is what I have exactly.

 

[ROCKSTAR]

may be ok, some guys run a 34mm. your carb is a bit different. the fuel inlet is on the opposite side. so it may be a different series, or a 35mm or whatever. sometimes with different carbs they change little things like that.....for a throttle cable..hmm..i would assume that a tors elim cable will work. the cable has to have a smaller barrel on the carb end. i havent seen a blaster tors cable in forever. but as long as the cable fits inside the carb and moves the slide, you should be ok. if i had a picture i'd show you, but i dont......