HELP!!! halfway through oil inj. block off

[MasterBlaster55]

OK so i got the TM oil injection block off kit, im at the point where i need ot remove the main case and i cant get it off...ive got the kickstarter, brake lever and oil pump removed and ive wiggled the casse loose just a bit but on the side were the oil pump came off its hanging up and i cant get the main cover off...any ideas

 

[03blasteryfs03]

tap wid hammer EASY

 

[liljatownboy]

um pull near the dowel pins one is on the lower right side and one is on the lower left

 

[liljatownboy]

could also tap it with a hammer but not too hard are u doing it with the engine on the bike still?

 

[MasterBlaster55]

Thanks for the hammer tip, it came off, but i have a nw problem...the metal tube going through the case(where the block off plate will go) wont come out...and ive tried the hammer. ive got the plastic gear and the c clips and the pin and that steel bar out...is it threaded maybe?

 

[danyoung582]

Thanks for the hammer tip, it came off, but i have a nw problem...the metal tube going through the case(where the block off plate will go) wont come out...and ive tried the hammer. ive got the plastic gear and the c clips and the pin and that steel bar out...is it threaded maybe?

never had that problem with mine, sorry no idea...
mine just unscrewed with 2 screws and came out....
sorry

 

[burnin'_oil_2001]

Thanks for the hammer tip, it came off, but i have a nw problem...the metal tube going through the case(where the block off plate will go) wont come out...and ive tried the hammer. ive got the plastic gear and the c clips and the pin and that steel bar out...is it threaded maybe?

Both of my Blasters did the same thing. Take the rubber gasket with the spring on the inside out with a screwdriver and then support the case. Next, put a dowel, punch, or screwdriver handle on the outside part of the bushing and tap it. Mine came out somewhat easy once I did this. It has been awhile and this is from memory but it should be close enough to get the idea. If not post back and I will go look it up for you. Again, I hope this helps. I:I

 

[MasterBlaster55]

Thanks for all the help guys...Im done, it may have taken longer than usual but hey...im new at this stuff and i appreciate the advice