Installed a PC pipe and have some severe bog between 1/4 to 3/4 throttle. I'm trying to do some carb re-jetting. I wanted to look at the needle jet and clip setting but the two tiny screws in the carb slide which I believe need to be unscrewed to access the needle are stripped. Can't seem to reach the screws with anything but a screw driver. I can't get one unscrewed. Any thoughts? thanks in advance for any help?
Help accessing Carb Needle and Clip
- Thread starter seitz729
- Start date
Have you tried adjusting the air screw any?
As to the screw, spray some PB Blaster on it , let sit. Maybe a little heat being careful not to direct it at needle. Take a good screw driver that fits well and tap on it to "renew" the head some what, then tap on it while turning it. It might work.
As to the screw, spray some PB Blaster on it , let sit. Maybe a little heat being careful not to direct it at needle. Take a good screw driver that fits well and tap on it to "renew" the head some what, then tap on it while turning it. It might work.
Yup, I was already 2/12 turns out of the air screw. I can't seem to get the stripped screw out. I think I will just try a different jet. Is this called the pilot or slow jet? I'm assuming I would need to go a size BIGGER?
Similar threads
