Full throttle bog

[Fiddler606]

Hello everyone, I'm new on here and I am looking for a little direction. I have a 2005 Blaster and just recently it started running like crap on hard acceleration. It runs like it is loaded up. I started by cleaning the carb and nothing looked plugged up or dirty. Then I replaced the plug thinking maybe it was getting bad. It ran good for a little bit but started running bad within 5 minutes. I have no experience with Tors but my compression is good and the reeds look good..sooo where would be my next direction? Also if I turn my gas off within 10 seconds it starts running awesome again. Any suggestions would be appreciated.

 

[Awk08]

if I turn my gas off within 10 seconds it starts running awesome again.

sounds like a float level problem
http://www.blasterforum.com/threads/float-heights-and-how-to-adjust-them.50565/

hows the reed petals look ?

 

[Fiddler606]

sounds like a float level problem
http://www.blasterforum.com/threads/float-heights-and-how-to-adjust-them.50565/

hows the reed petals look ?

They look good.. no cracks

 

[Blaaster]

Just maybe the needle and seat is allowing just too much fuel to enter the bowl due to a speck of dirt or a varnish buildup.

 

[Fiddler606]

Just maybe the needle and seat is allowing just too much fuel to enter the bowl due to a speck of dirt or a varnish buildup.

I removed every part of the carb and used carb cleaner and blew it out with the air compressor. I must have missed dirt or something the first couple times. It started running great again. Thank you for your help!!