front wheel clearance issues.

[zeke_752]

i just got the asr Lt +3 a arms and the factory yamaha aluminum front wheels will not clear the upper heim joint. i was wandering if someone ran into this. if i flip the wheels inside out they clear by a mile but my fourwheeler is almost too wide for some of my trails.

 

[brandoz28]

what offset are the front wheels?

 

[darederek]

Try some flush mount valve stems

 

[zeke_752]

im pretty sure they are the 3 on 2 im not 100% sure what they came off of i know they have yamaha stamped on them

 

[1995blaster]

they are prob banshee raptor yfz wheels since they are yamaha and aluminum

 

[Awk08]

yep, my asr heims are less then a 1/4 inch from rubbing my yfz front rims
and kdibson reported a similar problem, even going as far as saying when cornering hard they will rub
i looked into just using some seperate 1/4 inch thick washers/spacers on each stud to space them out a little, but said fug it, they're not hitting ...yet
and i too flipped the rims, it was ridiculously wide and my calipers were hangin out in the open for every rock known to jump at
i'd try adjusting them different and see what happens, suck the bottom heim in, top out, then adjust the arm heims at the frame to make up that difference ?????

 

[zeke_752]

i figured it out for now it isn't what i wanted to do but i had to put my stock steel front wheels back on. they clear perfectly fine. my problem was that the yamaha aluminum wheels were 10x6 and the stock blaster wheels are 10x5.5