Fixing small hole in muffler pipe....
- Thread starter Davo
- Start date
get rid and go back to stock or upgrade dg are rubbish. dont use gumgum exhaust repair i tryed it and it went very rong
Have done this with JB weld on car pipes. Get high temp jb weld and smooth it over good. Should hold just fine
quicksteel would probably hold. otherwise it would be easy to do with a torch or quick tig weld
its a muffler off a scrap blaster dude, settle
put the same crap everyone is putting on the exhaust flanges.....permatex copper rtv or the red high temp silicon or black sealant adhesive.....3 4 bucks a tube....it works good and when it stops working put more on
.....it also works better on car exhaust then any other crap they sell for exhausts....yet i do own a welder
someone put the red high temp on my yz250 exhaust and i could net even barely get it off with pliers/and all the kings horses and all the kings men
.....it also works better on car exhaust then any other crap they sell for exhausts....yet i do own a weldersomeone put the red high temp on my yz250 exhaust and i could net even barely get it off with pliers/and all the kings horses and all the kings men
lol i know my bad just before i posted that comment the cat scratched me the dog ran into me and put me on my ass and this was the first exhaust i had for my blaster payed a good bit for it then found out it was sh*t lol
i want to make that outfit lol
It's a muffler/silencer. At that point of the system, "brand" isn't gonna make much if any difference.
The bracket that holds mine on cracked off the muffler and I flux core welded it. looks like a little kid did it. I don't know how to use that welder yet.
