F7 Exhaust Coupler Size?

[DeJay1206]

I recently bought an F7 exhaust for the blaster that I'm rebuilding. I measured the exhaust with my caliper and it measured at 1.13 inches on the outer diameter and 1 inch inside diameter. Should I order a 1 inch coupler, or a 1.25 inch coupler from siliconeintakes.com? I know that obviously the 1.25 will work but I'll have to clamp it down a little tighter, just asking for some advice here!! Thanks

 

[armyboyjared]

I would go with the 1", it will be a bit tougher to slide on but will guarantee no chance of leaks when clamped.

 

[DeJay1206]

That's what I did. Got a one inch from siliconeintakes.com

 

[BlasterFun484]

I carry them in 10 colors prob for less shipped than anywhere else with clamps

 

[jus_me]

You will like the F7 pipe..

 

[DeJay1206]

I carry them in 10 colors prob for less shipped than anywhere else with clamps

Wish I knew that a few hours ago...

You will like the F7 pipe..

I can't wait. I had an fmf and upgraded to the f7...hope it's worth it

 

[jus_me]

I have the F7 and it hits really nice.. Its great without many mods and gets better as you go.. Btw what silencer are you going with?? Im using an fmf powercore 2 and it sounds good and the fit is really good, pretty much like they were made for each other.

 

[DeJay1206]

I have the F7 and it hits really nice.. Its great without many mods and gets better as you go.. Btw what silencer are you going with?? Im using an fmf powercore 2 and it sounds good and the fit is really good, pretty much like they were made for each other.

It's a whole f7 setup, pipe and silencer. I just put my fmf powercore 2 on my girls quad.

 

[jus_me]

Pics pics pics pics !!!

 

[DeJay1206]

Pics pics pics pics !!!

I still have to clean it up a little, but here she is