I have a few swing arms i am going to attempt to make an extended swing arm, does anyone have some info or any suggestions, thanks anything will help!
extended swing arm
- Thread starter bellaemma
- Start date
If I were going to do it I would use same size square tube cut swing sleeve tube and weld. This way you you get added strength and it does not go stock tube skinnier tube stock tube like the old YB swingers (which on another note, seen some of YB's poppin up on ebay lately.....what sh*t)
If you have several stock swingarms (2 needed in theory but if you make a mistake you may need mroe) laying around do like biggrobb762 did and make one out of two. For a stock extended swingarm, that's as trick as it gets.
The problem is using two swingarms to make one. Can't really do much with the two pieces that are left over.
The problem is using two swingarms to make one. Can't really do much with the two pieces that are left over.
Similar threads
