I just installed a top end on my bike. Bike is hard to start on first go and ran for like 15 min first run and sounded good. It wouldnt idle right until i remembered to install the air filter and lid (was spraying some carb cleaner in to help it fire up). bike didnt heat up until about 15 min and then i shut down.
I let the bike cool well over 30 min. More like couple of hours.
Second time. Bike hard to start. Had to use carb cleaner again to help fire it up. It then ran fine, but i checked it like 2 min it was hot. Is this normal on break in as first time it went about 15 min? I was keeping bike in my garage idle unless needing to keep it running until it would idle.
Thanks,
I let the bike cool well over 30 min. More like couple of hours.
Second time. Bike hard to start. Had to use carb cleaner again to help fire it up. It then ran fine, but i checked it like 2 min it was hot. Is this normal on break in as first time it went about 15 min? I was keeping bike in my garage idle unless needing to keep it running until it would idle.
Thanks,