Dynoport pipe and silencer
- Thread starter Shaf1070
- Start date
i know this is gonna sound dumb but try turing it in all directions and angles thats how i got mine to fit, and if it dont work try to take some pics if ya can
so i used my trusty crowbar and bent it a little to line it up to fit on the motor end, hopefully the point where the header and silencer meets will fit
i have what i think is a stock exhaust gasket ,should i use it or no?
i have what i think is a stock exhaust gasket ,should i use it or no?
you mean the rubber tube thing that goes over the silencer and header? ya mines a stock one but i had to scrape out some innerds to make it fit
naw the metal gasket that goes between the header and the engine
but im not puttin it in there to much of a pain in my balls
anyways i bent the pipe a little ,had it on and thought i should put the gasket in and took it off , now it wont go in again
very bad karma is headeing shafs way from me right now
so pissed i cant get it to work ,now i got a 200 dollar paper wieght
but im not puttin it in there to much of a pain in my balls
anyways i bent the pipe a little ,had it on and thought i should put the gasket in and took it off , now it wont go in again
very bad karma is headeing shafs way from me right now
so pissed i cant get it to work ,now i got a 200 dollar paper wieght
well that blows but im sure ull figure somthin out, i had to turn mine some crazy direction to get it in place
okay so i got it on , its definately not the right way but its on
the top bolt hole is waaaaaaaay off ,ya know the one on top of the pipe that hooks up under the gas tank
and i had to drill my own holes in the silencer tabs to make it work ,good thing i like using my dremel or i would prolly be doin some seious bashing right now
so two bloody knuckles and a few hours of time and its in
thanks for all the help guys rep points will be given out for this one
the top bolt hole is waaaaaaaay off ,ya know the one on top of the pipe that hooks up under the gas tank
and i had to drill my own holes in the silencer tabs to make it work ,good thing i like using my dremel or i would prolly be doin some seious bashing right now
so two bloody knuckles and a few hours of time and its in
thanks for all the help guys rep points will be given out for this one
mine was hell to put on! i had to cut a half inch off the end towards the header end and a half inch off the silencer were they meet. but boy it sounds great!
