DIY Video Request float level check

[brianfulcher15]

can somone make a quick video of how to check the float on a pwk carb.

I looked at the kehinin directions, but im still confused.

i need to know how to do us only using a regular metric ruler.

 

[Awk08]

no video, but a good pic, then you bend the little tab between the floats to adjust them up or down to the specified mm's
gasket removed when measuring to top of float, holding the carb as pictured, so float tang just touches the float valve

 

[brianfulcher15]

cool, i bet thats werhe my problem is, mines at like 24mm.

 

[brianfulcher15]

so to go lower i pull the tang up slighly right?

 

[Awk08]

yeah that sounds right, but you need to know the specs for your specific carb
stock is ...20 - 21.5 mm
my 34mm pj iis ....16 - 18mm

 

[brianfulcher15]

yeah that sounds right, but you need to know the specs for your specific carb
stock is ...20 - 21.5 mm
my 34mm pj iis ....16 - 18mm

this is measureing from the highest point of the float in the middle right.

 

[slickerthanyou]

Yes .

 

[Demo4o1]

im dialing in my 28mm pwk. my correct float height is 19mm. but how do i measure it? 19mm is waay too big from the pic. unless im using the wrong measuring tool. i dont get it