ok so i got my new clutch and i woke up and went to go put it on. i took out the old pressure plates and sh*t and then i put the new ones in with a plate first and last. the clutch just wont engage. i started it and i pull in the clucth and it seems like there no springs there at all. i put new aprings in there and everyting. also i dont know why but there is a lil room inbewtween the pressure plate. this didnt happen when te stock one was in. also there was a ring that was in there, its not flat its wavy and i dont know if im supposed to put i back in there with the new one or leave it out. when i put the new one on i started it and i pulled the clutch in, put into gear and let out the clutch it didnt even stall, wtf is wrong if anyone would help me that would be really helpful cause my dads gonna kill me if i dont fix this. thanks guys-Angelo
clutch problem, wtf is happening
- Thread starter aulicino69
- Start date
ya agreed, there should be a dot on the pressure plate and the inner hub line those up. also you put that "wavy" ring back in right?
ok do i have to put that wavy ring back ing because theres a space so when the pressure plate is installed the can frelly move around a few cms, is this bad? and what is the lil clutch ball? and one of my screws broke that goes into the pressure plate. is it ok if i ride it with only 4 springs and leave one oue? ive told that this is ok it will make the clutch a lil softer
ok thanks for the help, where u think i can get another screw from so i can put the fifth spring on
Depends on what kind of clutch kit you used. Stock=yes
Some aftermarket ones=no they use and extra friction plate.
Agreed! mine came with instructions that gave me an option to leave it in or use the full size extra plate and delete it.
check and see your directions. I pretty sure with 7 full size plates you do not use it.
