Choke Plunger not staying out

[xJust_Causex]

Yep thats my problem. There for awhile you could pull it out and very carefully let off it and it would catch but as soon as the motor would start it would pull back in unless you held it. Well I went to start it the other day and it would stay out at all, and not really sure where to start to fix the problem, I need to pull the carb off and clean it anyway so its actually pretty good timing for it to stop working.

 

[royalt67]

The plunger needs to be replaced. It just screws out of the carb. You can get one from the dealer or online.

 

[Blaner]

mine does that too, but i only need to to start and i hold it for a few secs then it idles without it. try richening up on the idle screw a bit

 

[98blaster+4]

ghetto fix......tie some fishing line to it and tie it off to the bars so that it will stay up........or just go get a new plunger, i dont happen to have one myself but theres lots of members on here that have old carbs laying around for parts . anybody got one to give this guy to help him out? if i had a spare you could have it

 

[bagds101]

i just sold one for 5 bucks.

 

[blasterdemon7]

I got one laying around. I think it works fine. I'll check it to make sure.

 

[theblasterboy]

i have to hold mine

 

[Drifz1]

use a cloths peg,i had to use one on my yfz

 

[00blaster200]

i have the same problem. I usually just wedge something in it to make it stay out.

 

[blasty98]

mine does the same thing i just hold it out till its warmed up then let go....then go rip

 

[mac2mac]

I think everyone has this problem. How much is a new one.. I fixed an old one with super glue... it was old and had cracks in it

 

[Antec1200X]

i have to pull mine out
alwaya has been like that and always will be imo

 

[R&S Polishing]

had same problem with one of my kids blasters went to local shop to order one it was $49.95 OUCH!!!! so i will just keep holding it out!!!!

 

[xJust_Causex]

Ya if I had to spend 50 bucks I'll live. Thanks for the info guys I think I'll just leave it as is for the time being.