carb still leaking
- Thread starter mud runner
- Start date
In the needle there is a plunger which is held out by a spring, it should push in about 2mm when pressed.
There should also be a fine, flat bottomed U shaped wire attatched to the needle.
When fitting the float the tang that pushes on the needle should be in that U formation.
Or do we get different needle and seat assemblies, due to the fact that we are upside down here in Aussie?
Dang sattellite connection is so slow that I cant get a pic up.
There should also be a fine, flat bottomed U shaped wire attatched to the needle.
When fitting the float the tang that pushes on the needle should be in that U formation.
Or do we get different needle and seat assemblies, due to the fact that we are upside down here in Aussie?
Dang sattellite connection is so slow that I cant get a pic up.
Last edited:
