i purchased the blaster carb rebuild kit..and there are a few parts i am unsure of where they go..there is a small o ring,a small c clip, and the skinny rod looking thing..i dont know where these go..any help would be much needed...
carb repair kit question???
- Thread starter beaten blaster
- Start date
skinny rod thing is the needle. the round part you pull out of the carb with the cap has a needle in the center of it. the clip is what holds that in place. not sure on the oring. but dont change the needle and clip. i wouldn't change the main jet either. oem jet's and needles are more accurately built than the stuff in a rebuild kit
my carb kit, had two rubber o rings, one for the drain screw on the float bowl. then there was one for the choke !
Sporty
Sporty
Similar threads
