carb question. will not start again.

[jumfleet]

I have a 88 blaster and the kid said it has a wisco piston and bored out. to what i dont know. it ran fine for a while or under a load but then when coming to a stop it would die. After sitting for a few min it would start again. it seemed .like if i was at an idle or after a load it would run like crap or die. the throttle overide is disconnected it looks like but the idle screw still works. I took the carb all the way off and took the bowl off to see if it was dirty or something. put it back together right away, everything back right. prior to that i messed with both screws, air fuel (copper screw on carb) and the throttle overide screw. put back together and now wont even wanna start again. i have no clue what to do. it seems like its getting to much gas cuz if i take the plug out and let it dry then try right away it wants to start at first but dies out.

some one please tell me what i can do to this turd to make it atleast start.

 

[chrismajcher]

take the carb , put it in a sock, and slam it into the concrete as hard as u can, then sell the pieces for scrap, and buy an aftermarket carb, it works every time!

 

[cirame1]

well check wat jet is in the carb and wats on it for aftermarket parts? i would get a new air filter if its not new, change the gas if its old and put a new plug... assuming u have the right main jet and its not clogged it should fire right up... may be bad compression if it doent wanna turn over so check compression with a compression tester. its gonna be either sumthin simple or ur gettin low on compression and it may be time for another piston.

 

[cirame1]

also wats ur gas and oil mix ratio?? should be using 32:1

 

[quam]

when you tried to kick it over after reinstalling the carb, did you kick it a buncha times? you realize that it'll take a few more kicks because you have to fill the bowl back up.....