bout to put some banshee brakes on some q's

[blaster 0108]

k i got my setup what is the easiest way to modify to fit the top ball joint i got the write up but seems kinda hard to me what other ways have u guys used to put the banshee brakes on ?

 

[blaster 0108]

this is for the fronts

 

[blaster 0108]

noone

 

[Blasterb0y794]

hope this helps man

ATV Riders Forum - How To: Convert Blaster Drums To Hydro Disks

 

[blaster 0108]

thats the one i have how do u know exactly where to drill the holes for the bolt and how good does that bolt hold it together

 

[newnick]

I wouldn't use that method unless I was completely broke. Either get some aftermarket arms that use a tapered balljoint or do as one of the other posters did and cut out the upper balljoint and weld in a new one that is tapered.

 

[ron89]

i have a banshee brake set up on mine cost me 20+ship well worth it hah .. umm i just welded the upper ball joint the spindle. and she works fine but its going to suck when i need to replace the ball joint, haha o well brake out the grinder ..

o and if you have the whole set up with the master cylinder and the brake lines, i would get the spilter and the 2steel line off a warrior they are shorter ..

 

[blaster 0108]

I wouldn't use that method unless I was completely broke. Either get some aftermarket arms that use a tapered balljoint or do as one of the other posters did and cut out the upper balljoint and weld in a new one that is tapered.

where would i get soem balljoints that i could weld on at?

 

[blaster 0108]

can i use warrior or banshee a arms and make them fit some way or is there no way to fit them up

 

[ron89]

i dont think warrior or banshee a-arms will work ..