blaster axle wtf

[riot7012]

i bought a blaster off of a cousin, and the axle comes out longer on one side, and i have to flip a tire around with the valve on the inside for the rear end to look correct:">

 

[89custom]

check to see if one side just has a widening spacer on it. if it doesnt, then make sure the center of the axle is right in the middle and for some reason its not pushed to one side. if non of the above, thats very strange.

 

[Stryder917]

haha, i've seen that a couple of times, sometimes people don't center the axle in the carrier when they work on it or remove it for some reason, make sure it is centered

also as ^^^^^^^^^^ said, it may be a spacer in one of the wheels instead of the axle itsself

 

[riot7012]

well my axle has hubs for 9 inch rims, and i dont see no spacers, so i have no idea what it is, also me and my dad jerked the head off today, and the piston was fried, and the oil was half water, how much damage do you think that water will do to my gears bearing etc.?

 

[Master_Blaster]

your probably gonna want to tear the whole lower end apart and replace the bearings just to be safe, especially if ur gonna rebuild it anyways.

 

[89custom]

sounds liek a pain in the ass. how much did u pay for it?

 

[riot7012]

i paid 200 dollars for it, its been bord .040 over, i fount piston, rings and gasket all for 119 dollars, im gonna rebuild it, and ride it for awhile then check my crank and stuff to see if its all still good

 

[Jabes]

heres a top end rebuild kit for cheaper good seller $100 bux with the top end bearing + shipping
Yamaha Blaster Wiseco Piston Kit 1988-2006
Yamaha Blaster YFS200 Top End Gasket Set K&S 1988-2006