bearing carrier help
- Thread starter armyblaster
- Start date
It will but the brake setup is different and you have to put spacers in between the carrier mounts and swingarm because the banshee carrier has a shorter mounting distance but the actual carrier where the bearings are held is identical. that being said you have to make sure u get the round part centered correctly if you just put it in the middle your sprockets will be off . Its about 1/8 on the chain side and abou 5/8 on the brake side . I did this on my blaster and dont have ne problems
Thats a matter of opinion.You can make it work with some spacers but I would not reccomend it.Sounds like a death trap waiting to happen.Not sure what you are trying to do but if you are looking to put a shee axle in it will go into the blaster carrier with no problems.
the axle will work perfect in an 03 an up blaster carrier the older carrier you need spacers to make the axle fit properly
It goes fine into the pre 03 carriers.The only difference on 03 and up and pre 03 is the brake mount.You do not need any spacers.I did it,run it,use it and it works like a charm.Again for the millionth time all you need is an axle and shee brake hub.All else will work from the stock setup.
