banshee plastics
- Thread starter mr_3_0_5
- Start date
yes.. they fit.. must85 is buildin a cr250 powered blaster right now.. he is going to pick up a set of used maier plastics in the morning.. they mave the fenders back further than the stock blaster ones, give us bigger riders a lil more room
yea is it a bolt up? my blasters real wide and i think banshee back fenders would take the weird look off my bike.
we will letyou know whats involved... prob have him write a diy post on it if he has to change anyhting
Ya i have them on mine they look sweet way better than stock blaster fenders alls you have to do is cut the old air box out of you fenders with the tabs on them and then cut the banshees fenders to fit but you have to make 4 new mounts if you dont want them to wooble all over and you dont need a new seat a stock blaster one works fine
sorry i took the pics but the pictures are way to big anyway to make them smaller so i can put them on
go to paint in all programs,.,your assesorys ( cant spel today) on computer.. open the pictures in paint and go to image at the top.. than on stretch skew.. and change the oris and veter down to 50.. that should make them small enough
View attachment 1103 this is where the box is cut out do this 1st and then cut banshees to fit around dont cut edges off to far or the side panales will be all over the place (learned that the hard way) seat keeps the front in place
View attachment 1104 this is where i had to weld my bumper to another pice of alumminum the bumper i had was to short and couldnt fit it on with out bringing it back and down
View attachment 1105 have to make your own bracket here unles you have the stock one then you can just cut that up and weld back to gether these are really just there to keep the sides up from flopping
View attachment 1106 cut this bracket just before the bend and then postion back on and make sure your fenders are flat and then weld back together
View attachment 1107 match up the plastics round things in the big hole dont know how to explain it but you will have to drill new holes for the bolts to be put back throgh
alls i can say is take your time when doing this dont rush its pretty simple to figure out on you own if you have the fenders there there is 1 more thing you have to do that i just learned is the 2 holes on the outside of the fenders you will have to make to brackets from the bumper to the plastics if you have the same bumper i do these will keep the fenders from flopping all over and whitening like mine have. sorry pictures are small as big as i could make them
View attachment 1104 this is where i had to weld my bumper to another pice of alumminum the bumper i had was to short and couldnt fit it on with out bringing it back and down
View attachment 1105 have to make your own bracket here unles you have the stock one then you can just cut that up and weld back to gether these are really just there to keep the sides up from flopping
View attachment 1106 cut this bracket just before the bend and then postion back on and make sure your fenders are flat and then weld back together
View attachment 1107 match up the plastics round things in the big hole dont know how to explain it but you will have to drill new holes for the bolts to be put back throgh
alls i can say is take your time when doing this dont rush its pretty simple to figure out on you own if you have the fenders there there is 1 more thing you have to do that i just learned is the 2 holes on the outside of the fenders you will have to make to brackets from the bumper to the plastics if you have the same bumper i do these will keep the fenders from flopping all over and whitening like mine have. sorry pictures are small as big as i could make them
Last edited:
where do you want me to pictures ill go take and post wat ever ones you want 2marro mourning
Last edited:
