ball joints

[bansheedave]

You all know, I think, I am running ASR +3+1 a arms and a full hand a 250r brake and spindle setup. My question is this, do you think I can run honda ball joints with these a arms or will the need to be modified to run ball joints? Just curious mainly.

 

[Awk08]

as long as the honda ball joints have the same diameter/thread. they should go right on,
thats part of the beauty of most A/M arms, they allow you to run most any ball/spindle combo

 

[bansheedave]

Sweet, thanks awk. I will look into them. I think I will have better geometry with actual ball joints. Sounds odd since hiem joints are suppose to over travel. But I'm actually having issues with the pins rotating in the spindle. So they aren't sitting in the taper very well and they are Honda spindle pins made by asr.