450 A-arms

[twinstaxx]

The 450 aarms do not fit the frame mounts.The top and bottom aarm is to wide. Also the top ball joint does not fit. The 450 ball joint is too small, you would have to use the 450 spindles. I can make them fit the frame but not the spindles unless I cut a piece on the laeth. i will keep you updated.

 

[twinstaxx]

check out the sig this is the mock up for the 450 a-arms

 

[djack12]

are you still gonna try and make them work?

 

[245stroker]

Looks like the front end sits too low with the 450 front shocks on it. Are you going to get longer shocks or run it like it is?

 

[twinstaxx]

i,ll measure when i get home and see how high it sets. the shocks are all the way down. d, all have to cut is 4 pieces of metal for the top aarm and weld it up

 

[blastapole]

450's sit low.

 

[crxbart]

450's sit low.

Looks like some positive camber possibly too.

 

[twinstaxx]

It is not Finnish it will sit 1/2" to 3/4" lower then stock that is not much if i dint like it i will move the shock down & in to raise it up.those are the stock hubs i am wating on a set for a 450 to finnsh it
To make it handle good should the top of the wheels in a little or should they be level?

 

[twinstaxx]

do the +3 a arms add 3" or 3"on each side

 

[tjsdaname]

do the +3 a arms add 3" or 3"on each side

they add +3 to each side...

 

[crxbart]

To make it handle good should the top of the wheels in a little or should they be level?

in a little!

 

[twinstaxx]

thanks

 

[sinclair_christopher]

i wanna do this

so to make those arms fit (450 ones) did u just cut off on bracket and slide it back so the arms fits? i wanna know... cuz i wanna do this... just wanna know what u did to get arms to fit.. thanx man. pm me