2000 blaster pulls to right at higher speeds

[bagged2drag88]

anyone have ideas why this is pulling to the right when you start fast or high speeds??? one tire is lower on tread than the other.... put i dont see that pulling it as hard as it is... tie rods are even nothing is bent from what i see nor are the rims.... im confused.....

 

[mr_3_0_5]

could just be tire pressure. put some air in the right tire if its pulling right.

 

[98blasterworked]

might be the uneven tread... check ur pressure and keep it close... also make sure u dont have camber in the front wheels...

 

[brandoz28]

check what these guys have said above, and with the adjuster system on these its really easy to get the rear end out of square

 

[Blaner]

mine was doing that and i realised i had a bent a arm! eish!

 

[darederek]

check your wheel bearings too if one is dragging it could cause a pull

 

[NOVIS]

when i first got mine it pulled to the right. i let all the air out of the tires and put the exact same amount in each side and it was fixed.

 

[con8quest6]

check what these guys have said above, and with the adjuster system on these its really easy to get the rear end out of square

yeah, and its always most noticeable when you start trying to do a wheelie or something. lol

 

[98blasterworked]

mine did the same... i havent noticed it in a while i think it was different tire pressures.... should have new tires next week so ill check when i get it up and running.... need the wheels, tires, and an SSt silencer since they sent me the regular powercore 2 -.-

 

[bagged2drag88]

so on the bearings how do i know if they are bad???? everything looks good rolls smooths just not as much greese in this shaft as i thought how much should i do just pack it theres no set amount?