Recent content by yamahaulling

There is this chic at the track thats ridding a 08 raptor 250 w/GTR pipe and jet kit on it and she pretty much spanks my kid to the first corner every time. The 4-stroke deff has some good tourque!!

Yes, pitboss is right on the money. Unless you have milled the head which will bump your compression up your motor will run better on 92 octane pump gas. Our blaster was milled 30 thousanths and produces 160 psi. It loves vp 117

We've never been touched by any 250 raptor. Or 350 raptor !!

I got the carb and the rear brake. message me!!

Its a tapered remming tool. Its kinda important becuase the ball joint that come with the buggard arms is tapered. It was 55 because for the bit or i payed 20 bucks at a local machine shop. A tight fit is important!!!

Yes, 245stroker is correct. A 240 kit would be legal in the blaster class!!

Well, Banshees are killer machines but would have to be pretty bad ass to keep up with our blaster. Im sure it would probably get us in a straight line. But them together on the track, and it would have no chance.

Make sure your reeds are ok.

Make sure that the real tiny, small, if it fell out you wouldn't even see it ball bearing didn't fall out. If you didn't mess with the clutch plates the ball bearing isn't your problem. But if you took the disk off then i'll bet the little ball bearing that goes in right before the shaft on the...

We live at 2200 feet and when we ran the stock carb we jetted at 270 when it was cold outside and a 260 when it was hot. and that was on vp and a highly modded 66 mil bore blaster. The main thing is ya just want the plug coco brown!!!!

God dam it seemed like he was in the for a life time.

I didnt use any of the factory hardware. They fit tighter than the virgin mary.

If a modded raptor 250 can't hang that red 250 doesn't have a chance. The last national we raced it was my sons blaster in first and 2nd 3rd and 4th were all 08 raptor 250s. My kid hanges in the 450 amature class locally. It all comes down to how its set up. Wouldn't trade this ride for anything...

Right on!!!!!

He's just not using that little black piece with the round hole. Oh yea when you put that piece in, make sure the matches the intake boot. Without that piece in there theres a 1/4 inch gap so it slide back wich allows th petal to fall out. Cost us 2 first place races because of it. Once i git...