i have a 98 blaster with no spark and the wiring is all out i need some help to try and figger out where it goes
wiring help
- Thread starter wright98blaster
- Start date
hey man welcome to the forum! pics eould really help the detail of the wires..... or just describe the wires...
man i just joined for the same thing! so your not alone! and someplease help us, like him i have no spark but all the wires are still on. i tried putting a new plug in and nothing happens, when i pull the plug out its covered in oil/gas mixer (just after a couple kicks) please help!
ok guys welcome to the forum.
both of you need a shop manual.
here is a down loadable check the harness out.
http://www.blasterforum.com/general-support-17/downloadable-yamaha-blaster-manual-17325/
it should help you out in figuring what wire colors are what and where the go and where they connect too.
and if that doesnt help let us know and we can try to help you out.
cause it could be a few problems the tors, stator, bad ground and so on.
both of you need a shop manual.
here is a down loadable check the harness out.
http://www.blasterforum.com/general-support-17/downloadable-yamaha-blaster-manual-17325/
it should help you out in figuring what wire colors are what and where the go and where they connect too.
and if that doesnt help let us know and we can try to help you out.
cause it could be a few problems the tors, stator, bad ground and so on.
well first off welcome to the forum,
how do you know that it could be your wireing?
have you disconected the T.O.R.S?
