wireing

daniel3877

New Member
Sep 17, 2007
456
5
0
upstate new york
hello everyone

i just recently did away with the oil injection
now i have two wires, a green and a black. i also have two more wires, yellow and black from the tail light that i did away with a long time ago..
im not sure how the oil tank wires work exactly, i know they must hook into the indicator light up on the dash.
how can i safely remove these without causeing issues?
they all are wrapped up together with the main harnessthat goes to the engine and coil.
id like to clean this mess up a bit. my tail light wires have been just hangin gthere for the past few years after removing tail light !

any advice from people that have removed wireing from this appreciated.I:I
 
Its all just wrapped up with tape.
I bought my son a Blaster setup to race and it still had all the wiring.
I removed all the tape on the wiring and just cut off the sections of wire I did not need, lites, tors, etc. Removed the voltage regulator. Then taped it all back up.
 
That is what I did too but I would cut part off, then start it up again to make sure. Then cut off the next part and start it up again. Just make sure if it is a hot wire, tape it off from any grounds or else you will let out the smoke. and we all know that once you let out the smoke it does not run anymore.