where can i get port and polishing
- Thread starter hudack
- Start date
there are a few motor builders on here that can do your port work for you talk to flotek, wild card racing, or kenedy power they are all reputable builders an can help you out with a price based on your needs
I got My Cylinder ported at Ken O'Connor Racing. i also sent him my carb, head, and timing plate. He Bored the carb, and did something to the timing plate, and Milled my head.
I ride in the woods and ever since i got the parts back this Machine is amazing! Its got major Bottom and Middle throttle response. This thing rips, I nicknamed it the Wheelie Machine. Total cost 280$
I ride in the woods and ever since i got the parts back this Machine is amazing! Its got major Bottom and Middle throttle response. This thing rips, I nicknamed it the Wheelie Machine. Total cost 280$
allright i wana get a 3+ crankshaft get a port job and the head milled i allready got it bored out 40. over
You likely know this, but just in case you don't, the .40 over bore does diddly for power, and a common misconception is that a .40 over-bore is the same as a 240. The .40 over is just to clean up and true the cylinder from past wear and damage.
well b4 i rebuilt it it wouldnt come close to my freinds 350 raptor 6th gear to 6th gear pined but now there nose and nose
you should be able to whoop that 350 with a lil work i was killin 350 warriors with just a stock setup an fmf pipe so with a p&p you shouldnt have any problems
kennedy or wild card in my opinion pm 370 hes a member and he does porting himself it's pretty good aswell
yea i sent kennedy a pm and im waitin for him to get back to me but right now im runin a fmf slip on aftermarket carb forget wat size lol and .040 wiseco piston
well b4 when i just had the fmf slip on id be pined goin up the road and him and my other friend would go past me with there middle fingers in the air to this day idk wat they were yellin tho lol
well if you were to regear your quad then you would gain some top end yamaha seems to undergear there machine from the factory
There's alot of feed back here on the builders mentioned.
Dig into the forums for builder feedback & PM builders for quotes.
Dig into the forums for builder feedback & PM builders for quotes.
