What are the chances i did any damage?

[Budget_Blaster]

I just got my blaster all done and finally took it out last weekend.
Everything was fine until I stopped to pull the plug and check it over and noticed that the IDLE set screw was missing from the side of the carb.Luckily i had a vacuum cap and plugged it and adjusted the throttle cable to get it to idle.

The thing runs good and showed no signs of damage other than a low idle speed.After getting it home i pulled the plug and using a mirror and flash light looked into the cylinder and other than running rich it looked normal.

I ordered a new idle set screw but my question is what if any damage do you think I may have done?The plug looked great and showed no signs of leaning out and neither did the top of the piston.

 

[stephen12091985]

you might have caught it in time for it to do no damage.how long was is out for?if you have a compression tester test the compression

 

[Blasterdude27]

I'm sure your fine, if your really worried check the comp.

 

[brandoz28]

i'm with the other guys...if it seems ok, it probably is and you caught it soon enough not to hurt it

 

[jgilbo17]

i wouldnt worry about it

 

[DUALSTROKE]

Like stated above,most likely you are ok.Get the screw and you should be good to go.

 

[motoman9911]

I'm going to go out on a limb and say your engine is trashed. A complete overhaul is now needed. Knowing that your Blaster needs a whole new engine I will give you one Benjamin Franklin for it. Haha

 

[Budget_Blaster]

I checked the compression it is 125psi what should it be or is this normal

 

[blasterfreek30]

thats about right for a stock motor......normal is around 130 psi