TORS

[20blaster06]

I recently installed the TORS eliminator kit on my 06 blaster, in which I removed the old cap and big contraption, not sure exact or proper term, on top of carb. I followed instruction about making hole flush where the idle screw was to be drilled and tapped and did so without issues. I then installed the new throttle cable and new cap and assembled everything but now if feels like I have very little, maybe half the throttle range-movement that I did have??
Ant ideas or help would be appreciated!

 

[Herpderplol]

how far in did you put the screw?

 

[20blaster06]

I

how far in did you put the screw?

figured it out about 20 minutes ago! The slide had a notch to ride thru-on and I wasn't lining it up but now she run right but the idle screw still don't go in far enough to do as intended. I ran it all the way in but won't idle? Not as disappointing as the previous issue cause we can ride! Thanks for ur help!

 

[Larry's Shee]

Pull the air cleaner boot so you can look in carb. Slide should have about 1/16-1/8 gap at bottom. Slide should start to move soon after you push thumb lever.
Adjust cable at carb and/or at throttle for proper slack

 

[Larry's Shee]

Sorry to say but you have to take it apart and file the carb body more where screw is.
Been there, done that 2X- Banshee

 

[Awk08]

file more off the boss to allow the idle screw to go in further,
it's a common issue when doing the idle screw install

 

[speedyslyder]

I

figured it out about 20 minutes ago! The slide had a notch to ride thru-on and I wasn't lining it up but now she run right but the idle screw still don't go in far enough to do as intended. I ran it all the way in but won't idle? Not as disappointing as the previous issue cause we can ride! Thanks for ur help!

uh huh glad you got it going nice work in your other thread i mentined the aligning of slide awesome