Throttle cable and fittings

[Racer51]

Hey you guys need some help in finding out why me throtle cable is so sloppy. I cant tell if it needs a fitting between the threaded part comeing from the box and the cable. Because I'm assuming the metal on the end of the cable fits onto an adjuster just like the clutch cable fitting does for adjustment. Because if there does it's not there would that account for having no tenshion on the throttle past half throttle.
So If you could post up pictures of your throttle boxes with an over top view with the rubber boot pulled down so I can get a good look at it. It would be appreciated. FFR I did look in my manual and the supplemental one as well and dosent seam to cover it so some input is appreciated thanks guys.

 

[Blaaster]

Page 3-3 of the manual tells how to adjuster coming out of the thumb throttle.

 

[Racer51]

Yes I know it's not a very clear picture though....thats why I'm asking for pics when it's convient. Thanks

 

[Blaaster]

Under the rubber boot is an adjuster with a lock nut, loosen the nut, adjust out the slack, tighten the nut.

 

[Blaaster]

Just re-read your first post, you are missing an adjuster, that explains why you have so much slack.

 

[Racer51]

???? There is the metal threaded piece with the lock washer piece thats supposed to be there on that on but it's still horably sloppy. that goes into the box but the cable has no backing to stay put in there. you can pull it right out to expose the wire but the pin stays into the groove/pin hole???????