Where does the little spring go in the Shindy kit? I have another one that I took out of the carb when I took it apart. I can't find one on the schematics for the carb. Does it go anywhere?
Spring in Shindy rebuild kit?
- Thread starter Fast6hand
- Start date
That's it. Thanks Awk. I was looking at the diagram wrong. Thought #20 on schematic was idle adjustment. But then I realized it didn't have one. It was on the TORS.
Awk what about the o-ring? There's a small one on the air/fuel screw already. Does another one go on after the spring?
It has one already on it. There's a separate o-ring in the kit. It looks like it may go on the choke or something.remove the old one, install the new one
I was weary about using the needle but it looked identical to stock. How are the jets in the kit? I read you should always use Mikuni jets.
yes, there's an o-ring on the choke stem too
clean and re-use your existing jets, unless the ones in the kit have the genuine "M" on them.
the airscrew is adjustable so it'll be fine to use
So is that where the O-ring goes? I didn't remove one when I took it apart. Would make sense if it goes on the choke. And the pilot I'm gonna reuse. However with my mods I need to step up the main.
Similar threads
