self oil blockoff

powerband

New Member
Feb 21, 2010
308
0
0
39
madison ohio
so i did my own oil block off and i just cut the lines and crimped them and clamped them.then took off the tank in the back. Is this all i have to do?
 
well i crimped the line to the carb along with the other one that i cut in half.im wondering why even get the blockoff kit if this is ok to do.
 
well i think your supposed to take the cover off and take the gear out that runs the oil pump and take the oil pump off...what your doing is a temporary fix to do it right
 
you take the oil pump off, then take off the clutch cover from the same side the oil pump was on and remove the little plastic gear attached to the inside of the case. make sure you take all the c clips off too. then re assemble and your golden.
 
you take the oil pump off, then take off the clutch cover from the same side the oil pump was on and remove the little plastic gear attached to the inside of the case. make sure you take all the c clips off too. then re assemble and your golden.

You forgot the block off plate.
 
ya dakota demon we both got infractions ..i was on your side ..not to sure what a infraction will do but i definitly could have been worse
 
Just finished my full dis-assembly with no issues, went to napa and bought vacuum plugs for a dime a piece. no block off plate....not necessary at all. might fab one in the future if i get around to it though....
 
I just ran a decent size bolt into the end of my hoses from my carb that went to the oil pump