Remove Axle from Swing Arm

[LOCSTA]

Can any one tell me how to remove the axle from the swing arm??? I'm parting out my blaster and someone wants the axle but I don't know how to get it apart.

Thanks

 

[Sandking]

Take the rear hubs off then the two nuts off the left side. Then youcan slide it threw to the right.

 

[LOCSTA]

Take the rear hubs off then the two nuts off the left side. Then youcan slide it threw to the right.

Sounds easy enough.

Thanks bro.

 

[Kieran]

yea its pretty simple, if seals have held up it should all slide out with a slight tap of a hammer, be careful of threads at end

 

[LOCSTA]

yea its pretty simple, if seals have held up it should all slide out with a slight tap of a hammer, be careful of threads at end

Thanks for the help.

 

[royalt67]

If it doesn't go easily, spray the crap out of the seals and bearings with wd-40 and wait a bit. Put the castle nut on it, use a block of wood to protect that and hit with a BFH.

It's much easier to remove the whole carrier from the swingarm. Then you can hold the carrier and tap the axle on a 2x4 on the ground.