i put a moose brake block on and now it feels like the pressure in the linnes how do i build them up
rear brakev wont work
- Thread starter 06blasterboy06
- Start date
lol its just like a car dude, pump the lever a few times to get pressure then crack the bleeder on the caliper, while still holding the lever the air will spit out then straight fluid, now close the bleeder and repeat the process untill you have good brakes.
no problem man its very easy just dont let your resivoir run empty because that will pump more air into the lines.
its just a seal, what im saying is when you crack the bleeder to get the air out some fluid will follow the air, if you do it enough times that will drain your res so just keep a eye on it.
U can also fill the master cyl up leave the lid and seal off crack both bleeders till they drip out a while
This method is called gravity bleeding
This method is called gravity bleeding
Sorry same method for the rear....unless its the older style with the cable system there. A pain
gravity bleeding doesn't really work well on the rear since the line sometimes goes higher than the rezzi and MC. the front is different though.
i personally like the vacuum bleed the lines first then do the normal pump and bleed style to get the good pedal.
i personally like the vacuum bleed the lines first then do the normal pump and bleed style to get the good pedal.
you can get a cheap on at harbor frieght. it work. you just pump it up a little to get the pressure going. then loose the bleeder valve. and keep pumping. just never let the fluid in the rezzi go low make sure to keep filling it up. and once you notice a solid stream of fluid coming out of the caliper and into the pump. you close the bleeder valve.
then you do the manual pump and bleed process which has been said.
Similar threads
